Suspension

Our GTX2 Lower Control Arms are now available for the FC3S RX7. These units replace the factory front lower control arms!  Specs: Fully adjustable on car Up to +30MM extra track Full Caster adjustment 23MM of adjustable bump steer reduction Heat...

We are happy to release our camber plates specifically designed for the 1st gen RX7. Since the SA and FB guys are really stepping up their interest, we've re-designed the camber plates to fit the SA, FB and the FC with no modifications to the chassis...

Check out our new Ultimate Tie Rod Package for the FC3S Mazda RX7!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and leverage!  Then we used very strong 5/8" bore...

All hardware plated providing a finish tough as nails. Solid 1" aluminum, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4" shank, and 5/8" bore, making them INCREDIBLY strong. The rod ends are also...

Introducing our Rear Camber Link for the FC RX7!!! Made with the same durability and adjustment that alot of our Links are known for having, our FC Rear Camber Link is made with a Solid 1" diameter 6061 aluminum coupler and our Three piece precision rod...

So...you built your coilover setup. Maybe you used HTS shocks or Koni Race dampers and cut your strut casings 40mm and find that the car is too low. Or you purchased a car that had some lowering springs that have had a coil cut one too many. Or you've...

Adjustable Sway Bar End Links for the FC3S RX7 3pc Teflon Lined Rod Ends  Stainless Steel Hardware