Billet 4 lug front hubs for the 240Z.

Machined from solid billet 6061 aluminum and anodized grey for durability.

Bolt pattern on the hubs is 4x114.3 (4x4.5") Factory Z bolt pattern

Comes with grade 10.9 bolt studs in factory 12x1.25 thread pitch.

Available with standard length studs or extra long racing studs

Comes with all races pressed in a new set of bearings.

Center caps included.

Front and rear mounting faces are in the exact same postion as the factory 240Z, so no special offsets are required to run these.

Long studs are 55mm underhead length.

Known fitment problems with TE37 V's due to the small diameter for the center cap. A 1/4-1/2" wheel spacer will be needed for clearance.