260Z

Our Z Lift Blocks are the perfect solution for a supension build that has gone wrong. If you've shortened your strut casings or cut your springs and now find that your car is too low, these blocks will raise your car up 1.25 inches! They are also a great...

Skillard's Aluminum Rear Camber Plate Covers for your S30Z. These are sold in a pair, hardware and trim are included. These are designed to cover the holes created when adding adjustable camber plates. (camber plates & coil overs are not included...

Skillard's 240Z Glove Box replaces the cardboard factory glove box with an all-aluminum one. Later, Datsun switched to a plastic glove box on the 280Z, after realizing that cardboard may not have been the best choice. The SKillard aluminum glove box...

Our Billet Steering Rack Clamps for the 240/260/280Z are machined from 6061 Aluminum for increased strength and rigidity over the factory stamped steel units.   Sold as a pair.  

Skillard's Front and Rear Conversion Brackets are multi-functional and are offered in several configurations. Intended for use on the Datsun 260Z and 280Z to convert to 240Z bumpers. The Skillard custom bumper conversion bracketry systems are ideal for...

  Looking to put the 88-92 Toyota 4Runner V6 4 piston S12W calipers and 1985 300ZX  vented rotors on the front of your Z? We've got the hardware! These rotor spacers make the swap a direct bolt on affair. Rotor spacers come in either...

If you have 240Z hubs, but wish to convert the backside offset to that of the 260Z or 280Z (If you have 260Z or 280Z brakes), then these these hub rings will do the trick. Machined for both 4 and 5 lug bolt patterns, these add the extra thickness of the...

Our Fancy Swaybar Clamps for the Z car are a beefy billet upgrade over the usual bent steel units. They pair perfectly with our billet aluminum Dogbone as well as our steel Dogbone and T3 Rear Swaybar! These will work with...

  Skillard Front Bumper Deletes for the Z cars.  These are custom made front bumper delete panels that are sold as a set. They are pictured on the 280Z but will also fit the 260Z and 240Z. They will work with after market air dams as shown...

Skillard 240Z Aluminum Glove Box Hinge. This setup comes with a new CNC cut and formed aluminum hinge as well as an aluminum door backer to mount it to. The hinge holes are slotted to fine tune door alignment. New mounting hardware is included. Finally a...

Over the years we have found that the S30 Z's Rear Lower Control Arms like to Toe-Out under acceleration. To minimize this problem we have created Solid Rear Lower Control Arm Bushings that offer zero deflection!  CNC Machined Bushings from self...