AE70

We designed these to the highest possible standards. No skimping on the expensive parts here. All Heim joints at both ends with metric sizes for a direct fit! Zero Slop, and Zero Deflection - this lateral rod is SUPER tight! The original bolt for the...

  These are the same custom Outer Tie Rods we've been offering for the AE86 and other cars for years now! We use very strong 5/8" bore rod ends with 3/4" shanks for these parts. The Rod Ends are 3-piece teflon lined to keep them quiet and long...

These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light weight, but solid and rigid. Powdercoated in fine wrinkle black for...

Meet our Evolved RCA's for the KE30 Corolla and all other 87mm strut spacing Toyotas! Using very clever geometry and hardware, these units can be used as a normal Roll Center Adjuster, Ackermann Adjust Roll Center Adjuster or Negative Camber Roll Center...

Meet our new Evolved RCA's for the AE86 and all other 85mm strut spacing Toyotas! Using very clever geometry and hardware, these units can be used as a normal Roll Center Adjuster, Ackermann Adjust Roll Center Adjuster or Negative Camber Roll Center...

  Swift is a high end manufacturer of coil springs from Japan and provides top quality products. Swift's Springs are wound with less coil than competitors allowing for more stroke and reduced weight! Noticeable increase in traction, smoother...

ARP Head Stud Kit; High Performance 8740 Series; 12Point Head for Toyota 4 Cylinder Engines: 2TC/3TC 20/22 R/RE/RET 4AGE/GZE 4AGE ST/BT20V 3SGE/GTE 1ZZGE 2ZZGE Clearly, ARP Head Stud/Bolt Kits are the best on the market today, and the favorite of...

Do you like to run your car low and deal with an excessive amount of droop that unseats the springs? Or maybe you're just tired of hearing a clunk when 3 wheeling out of driveways. Our new HyperCo Helper Spring Kit is the perfect solution for these...

  HyperCo Coilover Springs are the top choice of winning race car drivers and drifters worldwide! Proven in Indy, IMSA, and F1 to perform consistently, season after season. Advanced metallurgy, spring winding, and heat treating techniques...

Specifically made fro the E7 Corolla Wagon (Goon) rear doors. These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light...

Many of us remove the rear interior from our TE72. On the TE72,  this leaves an open hole to the trunk. This rear firewall is an aluminum panel to block off the trunk area for noise reduction and a more finished look. Panel is a bolt in part, using...