Toyota

Cusco Type II Rear Lower Bar for the ZZW30 Toyota MR-S. Type II Lower Arm Bar The Cusco Type II lower arm bar features the same tubular high-tension lightweight aluminum design and anti-corrosion paint as the Type I. The difference though, is that this...

Brand new Toyota Trunk weatherstrip seal for the AE86 Coupe. 

  HyperCo Coilover Springs are the top choice of winning race car drivers and drifters worldwide! Proven in Indy, IMSA, and F1 to perform consistently, season after season. Advanced metallurgy, spring winding, and heat treating techniques...

This pair of braces mounts using the factory lower seatbelt points just behind the seats.  Helps to reinforce the center of the car from the outer chassis to the tranny tunnel. Powdercoated metallic gunmetal. We put the big stickers on ours and we'll...

  Many AE86's are run very low. This changes the angle of the swaybar in relation to the car and changes the amount of leverage applied to the swaybar. In order to restore the correct swaybar angle, we've made these rear swaybar drop mounts. These...

Many of us remove the rear interior from our old cars.   On the TE31,  this leaves an open hole to the trunk. This rear firewall is an aluminum panel to block off the trunk area for noise reduction and a more finished look. Panel is a bolt...

Many of us remove the rear interior from our cars. This "parcel shelf" is a complimenting part to our rear firewall. It covers the rear speaker hole areas under the back window on the Coupe. Panel is a bolt in part, using factory mounting points. Made...

Many of us remove the rear interior from cars, or the cardboard panels have degraded significantly. These panels are a replacement for the rear interior side panels under the quarter windows. (where the rear passengers arm rests usually are) Made from ...

MA60 Radiator Shroud. Direct bolt on solution. Precision laser cut from 6061 Aluminum in Fine Wrinkle Black Powdercoat.    

Brand new Toyota Sunroof weatherstrip seal for the AE86.

From light weight aluminum. Available in fine wrinkle black powdercoat. This part will meet and exceed all your expectations for fit and finish. Fits both the Kouki and Zenki versions.