Suspension

Do you like to run your car low and deal with an excessive amount of droop that unseats the springs? Or maybe you're just tired of hearing a clunk when 3 wheeling out of driveways. Our new HyperCo Helper Spring Kit is the perfect solution for these...

  HyperCo Coilover Springs are the top choice of winning race car drivers and drifters worldwide! Proven in Indy, IMSA, and F1 to perform consistently, season after season. Advanced metallurgy, spring winding, and heat treating techniques...

This is a tri bar add-on for our Z rear strut braces. Light weight aluminum construction, machined brackets, and spherical rod end construction with right/left hand threading for an exact adjustable fit. Now with 3D machined bracket in anodized...

Our Z Lift Blocks are the perfect solution for a supension build that has gone wrong. If you've shortened your strut casings or cut your springs and now find that your car is too low, these blocks will raise your car up 1.25 inches! They are also a great...

Our Billet Steering Rack Clamps for the 240/260/280Z are machined from 6061 Aluminum for increased strength and rigidity over the factory stamped steel units.   Sold as a pair.  

If you have 240Z hubs, but wish to convert the backside offset to that of the 260Z or 280Z (If you have 260Z or 280Z brakes), then these these hub rings will do the trick. Machined for both 4 and 5 lug bolt patterns, these add the extra thickness of the...

Check out these sweet Sway Bar Clamps that we offer for the Front and Rear of your Z! These CNC Billet Aluminum Clamps will keep your Sway Bar locked down and performing perfectly! Plus they are a Cherry on top of all your T3 suspension...

Over the years we have found that the S30 Z's Rear Lower Control Arms like to Toe-Out under acceleration. To minimize this problem we have created Solid Rear Lower Control Arm Bushings that offer zero deflection!  CNC Machined Bushings from self...

  Our Rear Lower Control Arms Caps for the Z car are a nice billet upgrade over the factory stamped pieces.  Sold as Fronts, Rears, or Complete set with all necessary hardware.  NOTE: Our Long Nose Front Diff Mount (Factory Diff...

Did you convert your Z's Rear End to a Ford 8.8? Finding Studs to match the Nissan thread pitch is impossible so we had custom one's made!  These studs are sold in a set of ten and are 12x1.25 thread pitch with knurl to fit the BEEFY 2015 and up...

Looking for a simple solution for adjusting the rear camber and toe on the Z car? Here's the ticket!  Made from billet aluminum, anodized grey and using delrin inserts, these are a quick and easy direct install. Gives up to 2 degrees camber adjustment...