Techno Toy Tuning

For nearly a decade now Z owners have been struggling to reliably find replacement steering racks. Some rebuilt ones would pop up every once in a while, but turnaround times and the end product was...

Introducing our brand new S14 Ultimate Steering Rack! It's a direct OE Replacement with no modification required to install! We've had these Rack's produced with the most up to date friction...

Introducing our brand new S13 Ultimate Steering Rack Package! We've had a lot of interest in our S14 Ultimate Steering from S13 owners so we put a package together that makes install easy! It...

Check out our new Ultimate Tie Rod Package for the FC3S Mazda RX7!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

Check out our new Ultimate Tie Rod Package for the X-Runner!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

Check out our new Ultimate Tie Rod Package for the ZZW30 MR2 Spyder!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

  Techno Toy Tuning Velocitiy Stacks for the Weber, Mikuni, and Solex carburetors. Solid billet construction, these are machined from one piece of aluminum from beginning to end. Fully radiused...

Perfect for cracking open a cold one while you #BUILDSOMETHINGAWESOME!!! Features a built adjuster for Koni shocks! 

For those swapping to a different rear end, often times welding on new 4 link and panhard mounts is required. This full set of four 4-link mounts and panhard mount comes pre-asssembled and ready to...

  Sold in Pairs.  Laser cut steel weld perches for use on DIY coilovers. Weld these to the strut casings as a new perch for your threaded sleeve to sit on. 2 and 1/8" ID for a nice fit over...

Sold in Pairs.  Laser cut steel weld perches for use on DIY coilovers. Weld these to the strut casings as a new perch for your threaded sleeve to sit on. 2" ID for a nice fit over 2" OD strut...

Sold in Pairs. Laser cut steel weld perches for use on DIY coilovers. Weld these to the strut casings as a new perch for your threaded sleeve to sit on. 45mm ID for a nice fit over 45mm OD strut...