Techno Toy Tuning

Check out our new Ultimate Tie Rod Package for the ZZW30 MR2 Spyder!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

Check out our new Ultimate Tie Rod Package for the FC3S Mazda RX7!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

Check out our new Ultimate Tie Rod Package for the X-Runner!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and...

These are not your normal flat door cards. These have compound bends and hook over the top of the door, for a completely finished look. None of those sharp edges are exposed at the top. These also...

  Datsun 510 Universal Transmission Mount Allows you to bolt in the following Series Nissan Transmissions: L, FJ, Z, KA, SR, 200SX Dogleg, FJ Skyline, 280ZX Long 5speed. Raised sections on each side...

100mm Techno Toy Tuning Velocitiy Stacks for the 20v 4AGE!(or for use with our ITB adapter on your 16v!) Solid billet construction, these are machined from one piece of aluminum from beginning to...

  Techno Toy Tuning Velocitiy Stacks for the Weber, Mikuni, and Solex carburetors. Solid billet construction, these are machined from one piece of aluminum from beginning to end. Fully radiused mouth...

Perfect for cracking open a cold one while you #BUILDSOMETHINGAWESOME!!! Features a built adjuster for Koni shocks! 

SA and FB Rear replacement Watts Links. Rod ends are massive 3-piece teflon-lined, making them self lubricating and eliminating the need for a zirc fitting.   All spacing hardware is CNC'd Stainless...

For those swapping to a different rear end, often times welding on new 4 link and panhard mounts is required. This full set of four 4-link mounts and panhard mount comes pre-asssembled and ready to...

  Sold in Pairs.  Laser cut steel weld perches for use on DIY coilovers. Weld these to the strut casings as a new perch for your threaded sleeve to sit on. 2 and 1/8" ID for a nice fit over 2 and...

Sold in Pairs.  Laser cut steel weld perches for use on DIY coilovers. Weld these to the strut casings as a new perch for your threaded sleeve to sit on. 2" ID for a nice fit over 2" OD strut...