MR2

Looking to improve the handling of your vehicle? Our ST Anti-sway Bars are the ideal solution. By upgrading the anti-sway bars you reduce the amount of body roll and ensure improved handling while providing better traction. ST Anti-sway Bars improve the...

Cusco Pillar Side Bar for the ZZW30 Toyota MR-S. These bars are designed to add rigidity to the b-pillar area of the car on 2 door models. Because the 2 door models have a much larger opening for the door than a 4 door model, it needs more bracing to...

  Techno Toy Tuning Velocitiy Stacks for the Weber, Mikuni, and Solex carburetors. Solid billet construction, these are machined from one piece of aluminum from beginning to end. Fully radiused mouth for maximum airflow potential. Availabe in 40mm,...

All hardware plated providing a finish tough as nails. Solid 1" aluminum, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4" shank, and 5/8" bore, making them INCREDIBLY strong. The rod ends are also...

All hardware plated providing a finish tough as nails. Solid 1" aluminum, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4" shank, and 5/8" bore, making them INCREDIBLY strong. The rod ends are also...

Please note, you must measure your factory toe links from center to center of the mounting points, and choose the appropriate drop down above.  All hardware plated providing a finish tough as nails. Solid 1" aluminum, single piece arm design, providing...

Our Bomber Bar for the AW11 MR2 ties the front of the frame rails together to help stiffen the chassis and increase steering responsiveness. Now available with or without a Tow Hook! Direct bolt on part, takes only a few minutes to install.  Does...

  These are the same custom Outer Tie Rods we've been offering for the AE86 and other cars for years now! We use very strong 5/8" bore rod ends with 3/4" shanks for these parts. The Rod Ends are 3-piece teflon lined to keep them quiet and long...

Our 4AGZE crank pulley is 175mm in diameter for high boost on the GZE. On a bone stock 4AGZE this should raise the boost to around 14PSI. If your engine has a much larger intercooler, you will not see quite so high boost pressure, but you will see much...

Cusco Rear Strut Brace for the S/C AW11 Toyota MR2. The most popular of the Cusco bars is the Type OS. The classic design features a tubular aluminum oval shaft with a high polish finish. The aluminum bar possesses high rigidity due to the two different...

Cusco Type OS Front Strut Brace for the AW11 Toyota MR2. The most popular of the Cusco bars is the Type OS. The classic design features a tubular aluminum oval shaft with a high polish finish. The aluminum bar possesses high rigidity due to the two...