MR2

Our AW11 Racing Seat Rails are now ready! These will accommodate very short to very tall drivers with no problems! Fully adjustable for height and tilt. Design allows you to fit the seat between the seat rails and down super low. All stainless hardware...

For those needing less body roll and flatter handling in their MR2 Spyder, our new T3 Front Sway Bar is the best way to go! We've designed our Front Sway Bar to be stiffer than other available options on the market to meet the demands of track focused...

This kit includes our 175MM 4AGZE Crank Pulley, Smaller Belt Tensioner Pulley, and the longer supercharger belt needed. Our GZE crank pulley is 175mm in diameter for high boost on the GZE. On a bone stock 4AGZE this should raise the boost to around...

These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light weight, but solid and rigid. These hook over the top of the door...

Check out our new Ultimate Tie Rod Package for the ZZW30 MR2 Spyder!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and leverage!  Then we used very strong 5/8" bore rod ends...

All hardware plated providing a finish tough as nails. Solid 1" aluminum, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4" shank, and 5/8" bore, making them INCREDIBLY strong. The rod ends are also...

New updated design has better clearance for use in an AW11 MR2, now uses cylinder heads dowels for alignment and more accurate port matching!! Billet ITB Adapter for the Big Port 16V 4AG. This ITB adapter will allow you to bolt the individual...

Cusco Pillar Side Bar for the ZZW30 Toyota MR-S. These bars are designed to add rigidity to the b-pillar area of the car on 2 door models. Because the 2 door models have a much larger opening for the door than a 4 door model, it needs more bracing to...