Weld-On Panhard Mount for the AE86 and other Old School Toyota's.
Standard size is 2.5 inch to fit a Toyota Axle
Large is 3.0 inch to fit a Ford 8.8 Axle
Weld-On Panhard Mount for the AE86
Related Products
Weld on Mounts for AE86/Celica and Ford 8.8 Rear End Swap
For those swapping to a different rear end, often times welding on new 4 link and panhard mounts is required.
This full set of four 4-link mounts and panhard mount comes pre-asssembled and ready to...
$335.00
AE86 Factory Toyota Transmission Mount
Tired of that clunking transmission, but don't want the harshness of a racing tranny mount? An original Toyota mount is the answer for you!
$105.00
Add to Cart
The item has been added
Lateral Rod Drop Mount for the AE86 Corolla
AE86 Lateral Rod Drop Mount
On lowered AE86's this allows you to correct the roll center on the rear end of the car, and restore panhard geometry back to what Toyota intended.
This also helps to...
$185.00
Add to Cart
The item has been added
AE86 Door Cards
These are not your normal flat door cards. These have compound bends and hook over the top of the door, for a completely finished look. None of those sharp edges are exposed at the top.
These also...
$275.00
Clock Bezel for the AE86
You'll be absolutely amazed an how much fresher your car looks with new trim bits.
These are OEM Toyota clock bezel. Brand new and in the box.
Just do it. Your Corolla deserves this!
$50.00
Add to Cart
The item has been added