Datsun/Nissan

REAR door cards for the 4 door Wagon! These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light weight, but solid and rigid...

Many of us remove the rear interior from our cars. This "parcel shelf" is a complimenting part to our rear firewall. It covers the rear speaker hole areas under the back window on the Coupe. Panel is a bolt in part, using factory mounting points. Made...

Many of us remove the rear interior from our S13 240SX. On the AE86 Coupe,  this leaves an open hole to the trunk. This rear firewall is an aluminum panel to block off the trunk area for noise reduction and a more finished look. Panel is a bolt in...

Many of us remove the rear interior from our S13.  These panels are a replacement for the rear interior side panels under the quarter windows. (where the rear passengers arm rests usually are) Made from .050 aluminum, very light weight, but solid and...

REAR door cards for the 4 door Sedan These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light weight, but solid and rigid...

Many of us remove the rear interior from our cars. This "parcel shelf" is a complimenting part to our rear firewall. It covers the rear speaker hole areas under the back window on the Coupe. Panel is a bolt in part, using factory mounting points. Made...

Many of us remove the rear interior from cars, or the cardboard panels have degraded significantly. These panels are a replacement for the rear interior side panels under the quarter windows. (where the rear passengers arm rests usually are) Made from ...

NEW DESIGN: Our new design covers the complete rear area, and arcs over the fender wells for a much cleaner look. Note Installed Pics! Rear Trunk Firewall for the Datsun 510 Sedan.  Many of us remove the rear interior from our 510, leaving an open hole...

Our Billet Steering Rack Clamps for the 240/260/280Z are machined from 6061 Aluminum for increased strength and rigidity over the factory stamped steel units.   Sold as a pair.  

The large rectangular opening for the rear hatch allows a lot of chassis flex on the S13. This bar uses the two factory built in threaded sockets on the rear C-Pillars and helps to tie the whole chassis together. Made from lightweight but strong DOM...

  Looking to put the 88-92 Toyota 4Runner V6 4 piston S12W calipers and 1985 300ZX  vented rotors on the front of your Z? We've got the hardware! These rotor spacers make the swap a direct bolt on affair. Rotor spacers come in either...

If you have 240Z hubs, but wish to convert the backside offset to that of the 260Z or 280Z (If you have 260Z or 280Z brakes), then these these hub rings will do the trick. Machined for both 4 and 5 lug bolt patterns, these add the extra thickness of the...