RA40

For those swapping to a different rear end, often times welding on new 4 link and panhard mounts is required. This full set of four 4-link mounts and panhard mount comes pre-asssembled and ready to weld on. Available for both normal OD AE86/Celica...

  Our Front Bolt-On Coilover Kit was designed as a "slip on" option for those using full length shocks and looking for the ability to adjust their ride height. It includes short sleeves, spring perches, upper hats, and your choice of spring rate!...

Our Front Weld On Coilover Kit is the exact same kit we use on all of our coilover conversions. It includes a pair of longer sleeves, weld on perches, upper hats, and your choice of spring rate!  The kit was designed for the "do it yourselfer" that...

  T3 Black Camber Plates! The bearings on these are inserted into the aluminum blocks with what is called an "interference fit". What that means is that the holes that the bearings go into are actually a hair smaller than the bearing going into them...

 All solid steel construction  All hardware plated or powdercoated (The grey stuff is powdercoating) providing a finish tough as nails. Solid 1" steel, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4"...

We now offer 3 different levels of Rear Short Stroke Shocks to fit your budget and specific driving needs! Now….what’s the difference in these 3 damper choices? I’m sure it can seem a bit confusing with so many options...

  Techno Toy Tuning Velocitiy Stacks for the Weber, Mikuni, and Solex carburetors. Solid billet construction, these are machined from one piece of aluminum from beginning to end. Fully radiused mouth for maximum airflow potential. Availabe in 40mm,...

We now have do it yourself weld on lower control arm kits! For those that have the resources, this is a more affordable option than our complete lower control arms. This is also a much more modular setup, allowing use on many more models of cars! These...

We designed these to the highest possible standards. No skimping on the expensive parts here. All Heim joints at both ends with metric sizes for a direct fit! Zero Slop, and Zero Deflection - this lateral rod is SUPER tight! The original bolt for the...

  These are the same custom Outer Tie Rods we've been offering for the AE86 and other cars for years now! We use very strong 5/8" bore rod ends with 3/4" shanks for these parts. The Rod Ends are 3-piece teflon lined to keep them quiet and long...