Toyota

Introducing our new Evolved Camber Plates for the AE86! We've updated the design of our original Camber Plates to now allow for caster adjustment as well! You can install them as normal camber plates or rotate them 45 degrees to benefit from the new...

Fully Fabricated Steel Lower Control Arms (No used OEM parts)! Double Adjustable hardware (extend or shorten on car, no unbolting) All plated or stainless hardware. Oversized Teflon lined 3 piece rod ends on inboard side. Body is powder coated Metallic...

For those swapping to a different rear end, often times welding on new 4 link and panhard mounts is required. This full set of four 4-link mounts and panhard mount comes pre-asssembled and ready to weld on. Available for both normal OD AE86/Celica...

For those needing less body roll in the rear of the car, we offer the Cusco swaybars. We generally use a TRD or Cusco swaybar interchangeably.  TRD swaybars have been hard to come by lately but, thankfully, we have the super high quality Cusco available...

TRD Short Stroke Race Dampers (adjustable). These are the  blue model's which are for race handling use. Best for cars sitting 2" or more below factory height. For use with much  firmer than factory spring rates. Best for use with lowering...

The bearings on these are inserted into the aluminum blocks with what is called an "interference fit". What that means is that the holes that the bearings go into are actually a hair smaller than the bearing going into them. What we do is freeze the...

The bearings on these are inserted into the aluminum blocks with what is called an "interference fit". What that means is that the holes that the bearings go into are actually a hair smaller than the bearing going into them. What we do is freeze the...

  Our Front Bolt-On Coilover Kit was designed as a "slip on" option for those using full length shocks and looking for the ability to adjust their ride height. It includes short sleeves, spring perches, upper hats, and your choice of spring rate!...

Our Front Weld On Coilover Kit is the exact same kit we use on all of our coilover conversions. It includes a pair of longer sleeves, weld on perches, upper hats, and your choice of spring rate!  The kit was designed for the "do it yourselfer" that...

On this particular chassis car, the cars came with 3 different strut top patterns. Please look at the diagram above, measure the strut top on your car, and choose your camber plate design accordingly. The bearings on these are inserted into the aluminum...

 All solid steel construction  All hardware plated or powdercoated (The grey stuff is powdercoating) providing a finish tough as nails. Solid 1" steel, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4"...