Mazda

For 1986-1988 MAZDA RX-7 Series 4 (fits Naturally Aspirated and Turbo); 1.3This Part Fits:YearMakeModelSubmodel1988MazdaRX-710th Anniversary1986-1987MazdaRX-7Base1987MazdaRX-7Base...

Manual Transmission only. FB Chassis 83-85 1.1/1.3L (Including GSL-SE Trim) Includes M12 x 1.25 provision for low coolant sensor located on top tank center. Does not include emissions switch provision on driver's side bottom tank.This Part...

Introducing our Evolved Knuckles for the SA/FB RX7! These are a beautiful replacement for the factory knuckles with the added benefit of a quick steering Outer Tie Rod mount!    5 Axis CNC Machined Billet Steel  Zinc Plated for corrosion...

K&N Typhoon Short Ram Intake for the 1999-2005 Mazda MX-5 Miata. Available in two colors; Silver/Polished or Red.  The K&N 69-6000TP Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit...

SAFB RX7 Racing Harness Bar now available. From DOM steel, Powdercoated fine wrinkle black for the ultimate in durable finish. Laser cut T3 Logo. Mounts using both the upper and lower seat belt mounting points in the chassis. for a direct bolt in...

Koyo 99-05 Mazda MX-5 Miata 1.8L (MT) RadiatorThis Part Fits:YearMakeModelSubmodel1999MazdaMiata10th Anniversary1999-2005MazdaMiataBase2000-2005MazdaMiataLS2004-2005MazdaMiataMazdaspeed2000-2003MazdaMiataSE2003MazdaMiataShinsen

For 1989-1997 MAZDA MX-5 Miata fits 1.6L and 1.8L; 1.6/1.8This Part Fits:YearMakeModelSubmodel1990-1997MazdaMiataBase1993MazdaMiataLE1994-1997MazdaMiataM Edition1991MazdaMiataSE1997MazdaMiataSTO

We are happy to release our camber plates specifically designed for the 1st gen RX7. Since the SA and FB guys are really stepping up their interest, we've re-designed the camber plates to fit the SA, FB and the FC with no modifications to the chassis...

We are happy to release our camber plates specifically designed for the 1st gen RX7. Since the SA and FB guys are really stepping up their interest, we've re-designed the camber plates to fit the SA, FB and the FC with no modifications to the chassis...

  T3 Black Camber Plates! The bearings on these are inserted into the aluminum blocks with what is called an "interference fit". What that means is that the holes that the bearings go into are actually a hair smaller than the bearing going into them...

 All solid steel construction  All hardware plated or powdercoated (The grey stuff is powdercoating) providing a finish tough as nails. Solid 1" steel, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4"...

Steering components for the SA/FB RX7 are becoming unobtanium but we're here to help! Introducing our Ultimate Idler Arm! Built strong to handle the abuse of wide sticky tires with 3 pc teflon lined bearings and delrin for a razor sharp...