Mazda

We are happy to release our camber plates specifically designed for the 1st gen RX7. Since the SA and FB guys are really stepping up their interest, we've re-designed the camber plates to fit the SA, FB and the FC with no modifications to the chassis...

  T3 Black Camber Plates! The bearings on these are inserted into the aluminum blocks with what is called an "interference fit". What that means is that the holes that the bearings go into are actually a hair smaller than the bearing going into them...

 All solid steel construction  All hardware plated or powdercoated (The grey stuff is powdercoating) providing a finish tough as nails. Solid 1" steel, single piece arm design, providing the maximum in rigidity Three piece precision rod ends with 3/4"...

Steering components for the SA/FB RX7 are becoming unobtanium but we're here to help! Introducing our Ultimate Idler Arm! Built strong to handle the abuse of wide sticky tires with 3 pc teflon lined bearings and delrin for a razor sharp...

Our 1st gen RX7 Racing Seat Rails are now ready! These will accommodate very short to very tall drivers with no problems! Fully adjustable for height and tilt. Design allows you to fit the seat between the seat rails and down super low. All stainless...

Raybrig never did made a big splash over here in the USA, as their products were just a little too expensive for the scene at the time. Raybrig is the racing division of Stanley Lighting (provider of nearly all OEM Japanese car light housings). Those...

These door cards are absolutely beautiful! They add a very clean and crisp look that looks updated, oldschool and racecar like all at the same time! Made from .050 aluminum, very light weight, but solid and rigid. Powdercoated in fine wrinkle black for...

70 amp internally regulated self exciting single wire Mini Alternator Kit for the SA/FB RX7!  This alternator has a higher output than the OE unit and is internally regulated! This allows you to remove the external voltage regulator from your engine...

Check out our new Ultimate Tie Rod Package for the FC3S Mazda RX7!  We started off by updating the Inner Tie Rods from the OE 12mm to high quality 14mm units. This provides added strength and leverage!  Then we used very strong 5/8" bore...

If you are looking to make more room in your engine bay but don't want to lose your power assisted brake's, we are now offering Super Small Brake Booster's for the AW11 MR2, AE86, KP61 Starlet, TE72 Corolla and SA FB RX7! We have designed a billet...

The 1st gen RX7 is known to be a handful at the limit. The factory watts link design tends to cause binding issues and cause snap oversteer at the limit.  Our panhard bar conversion helps to eliminate slop in the rear end and to help eliminate that snap...