Mazda

Cometic MLS Head Gaskets for the Mazda Miata/MX-5. 89-93 1.6L, 94-00 & 04/05Mazdaspeed 1.8L and the 01-05 1.8L. 80mm Bore for factory 78mm bore and up to 2mm over on the 1.6L. 84mm Bore for Factory 83mm and up to 1mm over on the 1.8Ls. If you need...

Many of us remove the rear interior from our  RX7's These panesl are a replacement for the panels behind the strut towers and leading up to the tail light panel. Made from .050 aluminum, very light weight, but solid and rigid. Powdercoated in fine...

Upgrading to a nice Aftermarket Steering Wheel can really change your perception of a vehicle. The look and feel of it in the hands will have you thinking "this is a freakin' Racecar!"  Typically these nice Italian Steering Wheels are...

Upgrading to a nice Aftermarket Steering Wheel can really change your perception of a vehicle. The look and feel of it in the hands will have you thinking "this is a freakin' Racecar!"  Typically these nice Italian Steering Wheels are finished off with a...

Our Toe Plates are a quick way to adjust your cars alignment at the track! With the plates resting against your wheels, you can simply use 2 tape measures to adjust your cars toe in or out! We also included a Bottle Opener in our plates in case you get...

We have curated a bolt kit featuring the most common sizes used on any Mazda! Replacing old corroded pieces with fresh ones not only dresses your car up nicely but makes future work a lot easier!  M10x1.25x30 Bolts quantity 20 M10x1.25 Flange Nuts...

The RX7's with Glass Sunroof's used plastic hardware that has deteriorated over time. It's easy to break and hard to find. We went ahead and reproduced the hardware from stainless steel so that it looks good and lasts a lifetime!    Kit's...

So...you built your coilover setup. Maybe you used HTS shocks or Koni Race dampers and cut your strut casings 40mm and find that the car is too low. Or you purchased a car that had some lowering springs that have had a coil cut one too many. Or you've...

If you are using our camber plates and need a little more height, these riser blocks are the ticket.  These gold blocks click into place between the camber plate bearing block and the camber plate, giving 1" additional height. These will work with...